Mating Plate for MRE board to Banebots Bearing Plate

For the AS5040 and AS5045 rotary encoder.

Mating Plate for MRE board to Banebots Bearing Plate

Postby createthis » Thu Jun 13, 2013 7:11 pm

Just an FYI,

I designed, in OpenSCAD, a mating plate between the Mad Scientist Hut MRE breakout board and the Banebots Bearing Plate for the P60 gearbox:
Image
Image
Image

Click here for more information or to buy the STL or SCAD files:
http://www.createthis.com/products/banebots-bearing-plate-to-mad-scientist-hut-mre-breakout-board-mounting-plate

I also sell 3d printed versions of this part and more (see link on the above page).

I really enjoy using the Mad Scientist Hut MRE breakout board. It gives me all of the data I need from the chip, and it's easy to mount and use. Shipping was prompt too. Thanks, Kirk!

Let me know if you need any other mating surfaces designed, or circuit board cases fabricated. I was using 1/8" plywood before I got my 3d printer. The plastic parts give a nice clean appearance, are zero hassle, and I have a lot of fun designing them.

--
Jesse
CreateThis.com
createthis
 
Posts: 2
Joined: Sun Jun 09, 2013 11:33 am

Re: Mating Plate for MRE board to Banebots Bearing Plate

Postby createthis » Wed Jun 19, 2013 6:11 pm

FYI, I've given this project it's own Microsite, separate from Create This. CreateThis.com is more of a Marketplace for 3d Printed digital and physical goods. These 3d printed parts have a specific purpose. You can now find the open source software and 3d printed case work at the DIY Servo project: http://www.diyservo.com

image.jpg
image.jpg (104.31 KiB) Viewed 8345 times
createthis
 
Posts: 2
Joined: Sun Jun 09, 2013 11:33 am

Re: Mating Plate for MRE board to Banebots Bearing Plate

Sponsor

Sponsor
 


Return to 10/12Bit Rotary Encoder

Who is online

Users browsing this forum: No registered users and 0 guests

cron